Personal Computer User's Guide

Installing System Board Options 9-9
 3UHVV)!WRHQWHU WKH6\VWHP6HWXSS URJUDPDQG FKHFNWKHYDOXHI RU
6\VWHP0HPRU\LQWKHO RZHUULJKWFRUQHURI 3DJ H
The system should have already changed the value of System Memory to reflect
the newly installed memory. Verify the new total.
NOTE: If the memory total is incorrect, turn off and disconnect your computer
and peripherals from their power sources. Remove the computer cover, rotate
the power supply, and check the installed DIMMs to make sure that they are
seated properly in their sockets. Then repeat steps 5, 6, and 7.
 :KLOHLQWKH6\VWHP6HWXSSURJUDPUHVHWWKHFKDVVLVLQWUXVLRQGHWHFWRU
E\FKDQJLQJ&KDVVLV,QWUXVLRQWR1RW'HWHFWHG
See Chapter 3, “Using the System Setup Program,” for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
 :KHQWKH6\VWHP0HPRU\WRWDOLVFRUUHFWSUHVV WKH(VF!N H\WRH [LWWKH
6\VWHP6HWXSSU RJUDP
 5XQWKH'HOO'LDJQRVWLFVWRYHULI\WKDWWKH',00VDUHRSHUDWLQJ
SURSHUO\
See your
Diagnostics and Troubleshooting Guide
for information on running the diag-
nostics and troubleshooting any problems that may occur.
,QVWDOOLQJD',00
If a DIMM is already installed in the socket you want to use, you must remove it. To
do so, follow the instructions in the next subsection, “Removing a DIMM.”
Use the following procedure to install a DIMM (see Figure 9-6):
 /RFDWHWKHSODVWLFVHFXULQJFOLSVDWHDFKHQGRIWKHVRFN HW3UHVVWKH
FOLSVRXWZDUGXQWLOWKH\VQDSRSHQ
 3UHVVWKH',00VWUDLJKWLQWRWKHVORWUXQQLQJGRZQWKHFHQWHURIWKH
VRFNHWXQWLOWKHVHFXULQJWDEVVQDSLQWRSODFHDURXQGWKHHQGVRIWKH
',00
)LJXUH,QVWDOOLQJD',00
securing
clips (2)
2.
1.
23186bk0.bk Page 9 Thursday, October 29, 1998 11:07 AM