Personal Computer User's Guide
8-2
'HOO3UHFLVLRQ'HVNWRS6\VWHPV8VHU©V*XLGH
,I\RXDUHGLVFRQQHFWLQJDSHULSKHUDOIURPWKHFRPSXWHURUDUHUHPRY
LQJDFRPSRQHQWIURPWKHV\VWHPERDUGZDLWWRVHFRQGVDIWHU
GLVFRQQHFWLQJWKHFRPSXWHUIURP$&SRZHUEHIRUHGLVFRQQHFWLQJWKH
SHULSKHUDORUUHPRYLQJWKHFRPSRQHQWWRDYRLGSRVVLEOHGDPDJHWR
WKHV\VWHPERDUG
To verify that all power has been removed from the system, make sure that the
standby light-emitting diode (LED) on the system board has gone out. For the
location of this LED, see Figure 9-1.
7R XF KDQXQSD LQ WH GPHWDOVXUIDF HRQ WKHFRPSXWHUFKDVVLVVXFKDVWKH
SRZHU VXSSO\EHIR UH WRXFK L Q JDQ\WK LQ J LQ VLGH \RX U FRPSXW HU
While you work, periodically touch an unpainted metal surface on the computer
chassis to dissipate any static electricity that might harm internal components.
Also avoid touching components or contacts on a card and avoid touching pins on
a chip.
In addition, Dell recommends that you periodically review the safety instructions at
the front of this guide.
8QSDFNLQJ<RXU+DUGZDUH2SWLRQ
When you remove an option from its shipping carton, you may find it wrapped in anti-
static packing material designed to protect it from electrostatic damage. Do not
remove the packing material until you are ready to install the option.
&$87,216HH´3URWHFWLQJ$JDLQVW(OHFWURVWDWLF'LVFKDUJHµLQWKHVDIHW\
LQVWUXFWLRQVDWWKHIURQWRIWKLVJXLGH
5HPRYLQJWKH&RPSXWHU&RYHU
Use the following procedure to remove the computer cover:
7XUQRII\RXUFRPSXWHUDQGSHULSKHUDOVDQGPDNHVXUH\RXXQSOXJWKH
FRPSXWHUIURPLWVHOHFWULFDORXWOHWEHIRUH\RXUHPRYHWKHFRPSXWHU
FRYHU2EVHUYHWKH:DUQLQJIRU<RXU3HUVRQDO6DIHW\ DQG3URWHFWLRQ
RI<RXU(TXLSPHQWGHVFULEHGHDUOLHULQ WKLVFK DSWHU$O VRR EVHUYH WK H
VDIHW\L QVWUXF WLRQ VDWWK HIU RQW RIWK LVJXLGH
,I\RXKDYH L QVWDOOHG DS DGORF NWK URXJKW KHS DGORFN ULQ JRQ WKH
EDFNSD QHOVHH )LJX UH UH PRYH WKHS DGO RFN
23186bk0.bk Page 2 Thursday, October 29, 1998 11:07 AM










