Owners Manual

Installing the Input/Output (I/O) panel

1. Insert the I/O panel on the chassis and slide it until it clicks into place.

2. Tighten the screws to secure the I/O panel to the chassis.

3. Install the:

a) front bezel

b) cover

4. Follow the procedure in After Working Inside Your Computer.

Removing the system fan

1. Follow the procedure in Before Working Inside Your Computer.

2. Remove the:

a) cover

b) front bezel

c) hard drive

d) optical drive

3. To remove the system fan:

a) Disconnect the system fan cable from the system board [1].

b) Slide the fan grommets toward the slot on the back wall [2].

c) Lift the fan away from the computer [3].

Installing the system fan

1. Place the system fan in the computer.

2. Pass the grommets through the chassis and slide outward along the groove to secure it in place.

3. Connect the system fan cable to the system board.

4. Install the:

a) optical drive

b) hard drive

c) front bezel

d) cover

5. Follow the procedure in After Working Inside Your Computer.

Removing the heat sink fan cover

1. Follow the procedure in Before Working Inside Your Computer.

2. Remove the cover.

Removing and installing components