Owners Manual

Table 7. Performance (continued)
Option Description
Intel TurboBoost Allows you to enable or disable the Intel TurboBoost mode of the processor.
Default Setting: Enable Intel TurboBoost
Hyper-Thread Control
Allows you to enable or disable the HyperThreading in the processor.
Default Setting: Enabled
Cache Prefetch
Default Setting: Enable Hardware Prefetch and Adjacent Cache Line Prefetch
Dell Reliable Memory
Technology (RMT)
Allows you to identify and isolate memory errors in system RAM..
Default Setting: Enable Dell Reliable Memory Technology (RMT)
NOTE: This feature is supported in T3610 only when ECC memory modules are installed.
Table 8. Power Management
Option Description
AC Recovery Specifies how the computer will respond when AC power is applied after a AC power loss. You can set
the AC Recovery to:
• Power Off (Default)
• Power On
• Last Power State
Auto On Time Allows you to set the time at which the computer must turn on automatically. The options are:
• Disabled (Default)
• Every Day
• Weekdays
• Select Days
Deep Sleep Control Allows you to define the controls when Deep Sleep is enabled.
• Disabled (Default)
• Enabled in S5 only
• Enabled in S4 and S5
Fan Speed Control Allows you to control the speed of the system fan. The options are:
• Auto (Default)
• High
• Medium
• Low
USB Wake Support Allows you to enable USB devices to wake the system from standby.
Default Setting: Disabled
Wake on LAN This option allows the computer to power up from the off state when triggered by a special LAN signal.
Wake-up from the Standby state is unaffected by this setting and must be enabled in the operating
system. This feature only works when the computer is connected to AC power supply.
• Disabled - Does not allow the system to power on by special LAN signals when it receives a wake-up
signal from the LAN or wireless LAN.
• LAN Only - Allows the system to be powered on by special LAN signals.
This option is Disabled by default.
Block Sleep Allows you to block entering to sleep (S3 state) in OS Environment.
Default Setting: Disabled
42 System Setup