Owners Manual

Table 3. System Configuration (continued)
Option Description
Serial Port Identifies and defines the serial port settings. You can set the serial port to:
• Disabled
• COM1 (Default)
• COM2
• COM3
• COM4
NOTE: The operating system may allocate resources even if the setting is disabled.
SATA Operation
T3610 and T5610
Allows you to configure the internal SATA hard-drive controller. The options are:
• Disabled
• ATA
• AHCI (Default)
• RAID On
NOTE: SATA is configured to support RAID mode. No SATA operation support in T7610.
Drives
T3610 and T5610
Allows you to configure the SATA drives on board. The options are:
• SATA3–HDD0
• SATA2–HDD2
• SATA2–ODD0
• SATA3–HDD1
• SATA2–HDD3
• SATA2–ODD1
Default Setting: All drives are enabled.
NOTE: If the hard drives are connected to a RAID controller card, the hard drives will
display {none} in all the fields. The hard drives can be seen in the RAID controller card
BIOS.
• T7610 • SATA2–ODD0
• SATA2–ODD1
Default Setting: All drives are enabled.
NOTE: If the hard drives are connected to a RAID controller card, the hard drives will
display {none} in all the fields. The hard drives can be seen in the RAID controller card
BIOS.
SMART Reporting This field controls if the hard drive errors for the integrated drives are reported during system startup.
This technology is part of the SMART (Self Monitoring Analysis and Reporting Technology) specification.
• Enable SMART Reporting - This option is disabled by default.
USB Configuration Allows you to enable or disable the internal USB configuration. The options are:
• Enable Boot Support
• Front USB Ports
• Back Quad USB Ports
• Enable internal USB ports
• USB3 Ports
PCI Bus Configuration Allows you to configure the PCI buses. The options are:
• 256 PCI Buses (Default)
System Setup 39