Owners Manual

Installing the Input/Output (I/O) Panel

1. Replace the I/O panel in its slot.

2. Tighten the screws securing the I/O panel to the chassis

3. Attach the cables to the I/O panel.

4. Slide the USB 3.0 module in its slot.

5. Tighten the screws securing the USB 3.0 module to the I/O panel.

6. Install:

a. front bezel

b. cover

7. Follow the procedures in After Working Inside Your Computer.

Removing the Air Tunnel

NOTE: The air tunnel is an optional component and your computer may not ship with it.

1. Follow the procedures in Before Working On Your Computer.

2. Remove:

a. cover

b. optical drive

3. Press down on the retention tab on the air tunnel and lift it from the computer.

Installing the Air Tunnel

NOTE: The air tunnel is an optional component and your computer may not ship with it.

1. Install the air tunnel in the computer chassis.

2. Mount the air tunnel module on the base and press downwards until it clicks into place.

3. Install:

Removing and Installing Components