Owners Manual

Installing the Hard Drive

1. If a 2.5–inch hard drive is installed on the computer, place the hard drive on the hard-drive caddy and tighten the screws to secure the

hard drive.

2. Press in on the latches of the hard-drive cage and slide it inside the compartment.

3. Connect the hard-drive power supply cable.

4. Connect the hard-drive data cable.

5. Install the cover.

6. Follow the procedures in After Working Inside Your Computer.

Removing the Thermal Sensor

NOTE: The thermal sensor is an optional component and your computer may not ship with it.

1. Follow the procedures in Before Working On Your Computer.

2. Remove the cover.

3. Identify the thermal sensor connected to the system board.

4. Disconnect the thermal sensor from the system board.

Removing and Installing Components