Administrator Guide

6. In the Scheduling tab, click Next.

7. In the User Experience tab, select User notifications: Display in Software Center, and only show notifications for system restarts.

8. Click Next in the Alerts tab, click Next in the Summary tab, and verify deployment completion.

Verify deployment success in client systems

To verify the successful deployment in the client systems:

1. Open Software Center in the client system, verify if the Dell Precision Optimizer is installed.

NOTE: It may take a few minutes for the installation to take place after deploying the application

2. Go to C:\\Windows\CCM\Logs and check AppDiscovery.Log, AppIntent.log, and AppEnforce.log for troubleshooting

purpose.

Changing the Dell Precision Optimizer Client behavior

using DPOCMD.EXE

Following are the steps to run Dell Precision Optimizer CLI (dpoCmd.exe) on a target system to change the behavior of Dell Precision

Optimizer software on that system. The following example illustrates the use of dpoCmd.exe to enable a Dell Precision Optimizer profile

(After effects by Adobe).

Create a software package

To create a software package:

1. In the Configuration Manager Console:

a. Open the Software library page.

b. Click Overview tab.

c. Open the Application Management tab.

d. Right click Packages and select Create new package.

2. In the Create Package and Program wizard:

a. Set the Name: Enable a Dell Precision Optimizer profile.

b. Specify information about the package and click Next.

3. In the Program Type tab, select Standard program.

4. In the Standard program tab:

a. Name: Enable Adobe after effects

b. Command line:dpoCmd.exe –enableProfile {2F066600-FA52-4F57-890D-2621D39B0BE9}}

c. Startup folder: C:\program files\dell\ppo

d. Run: Normal

e. Program can run: Whether or not a user is logged in

f. Run mode: Run with administrative rights

g. Drive mode: Runs with UNC name

5. In the Requirements tab, select This program can run on any platform.

6. Click Next, review the package summary and verify the package was created successfully.

Deploy the Enable a Dell Precision Optimizer profile software package

1. In the Configuration Manager console:

a. Open the Software library page.

b. Click the Overview tab.

c. Open the Application Management tab.

d. Click Packages.

2. Right click the Enable DPO profile software package and select Deploy.

3. In the Deploy Software Wizard:

a. In the General tab, click browse to select the device collection, click Next.

Enterprise tools