Owners Manual

Table 10. Power Management (continued)
Option Description
● Disabled - Does not allow the system to power on by special LAN signals when it receives a
wake-up signal from the LAN or wireless LAN.
● LAN Only - Allows the system to be powered on by special LAN signals.
● LAN with PXE Boot - Allows the system to power on and immediately boot to PXE when it
receives a wake-up packet sent to the system in either the S4 or S5 state.
All the options are not set by default.
Block Sleep Allows you to block entering to sleep(S3 state) in OS Environment.
This option is not set by default.
Post behaviour
Table 11. POST Behavior
Option Description
Numlock LED
Specifies if the NumLock function can be enabled when the system boots. This option is set by
default.
Keyboard Errors
Specifies whether keyboard related errors are reported when it boots. This option is set by
default.
Extend BIOS POST Time
Allows you to create additional pre-boot delay and see POST status messages.
Click one of the following options:
● 0 seconds(Default)
● 5 seconds
● 10 seconds
Security Audit Display
Disable
Allows you to disable the display of the Security Audit results during POST.
● Disable Display Of Security Audit Display
This option is not set by default.
Full Screen Logo
Allows you to display full screen logo, if your image matches screen resolution.
● Enable Full Screen Logo
This option is not set by default.
Warnings and Errors
Allows you to select different options to either stop, prompt and wait for user input, continue
when warnings are detected but pause on errors, or continue when either warnings or errors are
detected during the POST process.
Click one of the following options:
● Prompt on Warnings and Errors—Default
● Continue on Warnings
● Continue on Warnings and Errors
112 System Setup