Owners Manual
Table Of Contents
- Dell Precision 7820 Tower Owner's Manual
- Chassis
- Working on your computer
- Removing and installing components
- Screw size list
- Recommended tools
- Power supply unit (PSU)
- Side cover
- Front bezel
- Hard Disk Drive bezel
- Hard disk drive assembly
- NVMe Flexbay
- Slim Optical Disk Drive
- Front input and output bezel
- 5.25 inch ODD bracket
- Front input and output panel
- Input and output panel bracket
- VROC module
- Intrusion switch
- Internal chassis speaker
- Air shroud
- Memory
- Graphical processing unit(GPU)
- Coin cell battery
- System fan
- Fan bracket
- PCIe holder
- Rear system fan
- Front system fan
- Processor heat sink module
- System board
- Technology and components
- System specifications
- System Setup
- Software
- Troubleshooting
- Contacting Dell
3. Flip both the processor and the carrier over so that the pins on the processor and the logo side of the carrier are facing up.
4. Carefully insert the processor into the carrier so that it is secured by the hooks on the upper and lower side of the carrier.
NOTE:
After inserting the processor into the carrier, check to see whether the small triangle on the processor aligns
with the triangle on the carrier. If they are not aligned repeat the preceding steps.
5. Align the processor and carrier assembly with the heat sink so that the triangle marks on the processor and carrier are
aligned with the triangle mark on the top side of the heat sink (captive screw #2).
Removing and installing components
67