Owners Manual
Table Of Contents
- Dell Precision 7820 Tower Owner's Manual
- Chassis
- Working on your computer
- Removing and installing components
- Screw size list
- Recommended tools
- Power supply unit (PSU)
- Side cover
- Front bezel
- Hard Disk Drive bezel
- Hard disk drive assembly
- NVMe Flexbay
- Slim Optical Disk Drive
- Front input and output bezel
- 5.25 inch ODD bracket
- Front input and output panel
- Input and output panel bracket
- VROC module
- Intrusion switch
- Internal chassis speaker
- Air shroud
- Memory
- Graphical processing unit(GPU)
- Coin cell battery
- System fan
- Fan bracket
- PCIe holder
- Rear system fan
- Front system fan
- Processor heat sink module
- System board
- Technology and components
- System specifications
- System Setup
- Software
- Troubleshooting
- Contacting Dell
Installing the slim ODD
1. Slide the slim ODD into the slot on the chassis.
2. Tighten the screw to secure the slim ODD to the chassis.
3. Install the side cover.
4. Follow the procedure in After working inside your computer.
Front input and output bezel
Removing front input and output bezel
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. side cover
b. front bezel
3. To remove the front input and output(I/O) bezel:
a. Pry the four retention tabs[1] from the chassis and push the bezel out from the chassis[2].
Removing and installing components
35