Owners Manual
Table Of Contents
- Dell Precision 7820 Tower Owner's Manual
- Chassis
- Working on your computer
- Removing and installing components
- Screw size list
- Recommended tools
- Power supply unit (PSU)
- Side cover
- Front bezel
- Hard Disk Drive bezel
- Hard disk drive assembly
- NVMe Flexbay
- Slim Optical Disk Drive
- Front input and output bezel
- 5.25 inch ODD bracket
- Front input and output panel
- Input and output panel bracket
- VROC module
- Intrusion switch
- Internal chassis speaker
- Air shroud
- Memory
- Graphical processing unit(GPU)
- Coin cell battery
- System fan
- Fan bracket
- PCIe holder
- Rear system fan
- Front system fan
- Processor heat sink module
- System board
- Technology and components
- System specifications
- System Setup
- Software
- Troubleshooting
- Contacting Dell
5. Lift the cover to remove it from the system.
Installing the side cover
1. First hold and align the bottom of the side cover to the chassis.
2. Ensure that the hook on the bottom of the side cover snaps into the notch on the system.
3. Press the system cover until it clicks into place.
CAUTION:
The system will not power on without the side cover. Also, the system will shut down if the side
cover is removed while the system is on.
4. Follow the procedure in After working inside your computer .
Front bezel
Removing the front bezel
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
Removing and installing components
19