Service Manual

h Remove the eDP cable bracket [2].

i Disconnect the eDP cable from the connector on the system board [3].

j Peel the adhesive tape that secures the eDP cable in place [4].

k Unroute the wireless cable from the routing channels located next to the hinges .

l Remove the display assembly [5].

Installing the display assembly

1 To install display assembly:

a Align the display assembly into the slots on the system [1].

b Route the wireless cable located next to the hinges .

c Ax the adhesive tape to secure the eDP cable in place [2].

d Connect the eDP cable to the connector on the system board [3].

e Place the eDP cable bracket and replace the single (M2.0x3.0) screw to secure the eDP cable bracket to the system board [4,

5].

Removing and installing components