Service Manual

h heatsink assembly

3 To remove the graphics card:

a Remove the 2 (M2.0x3.0) screws that secure the beam connector to the system board [1].

b Remove the beam connector from the system board [2].

c Remove the 3 (M2.5x5.0) screws that secure the graphics card to the system board [3].

d Remove the graphics card from the system [4].

NOTE: The above procedures are for UMA graphics card. Systems shipped with UMA GPU card do not have GPU

power cable. However, for discrete models shipped with either a 128 MB or 256 MB VRAM GPU card, you need to

disconnect the GPU power cable before removing the GPU card.

Installing the graphics card

1 To Install the graphics card:

a Slide the graphics card into its original position in the system [1].

b Replace the 3 (M2.5x5.0) screws to secure the graphics card to the system board [2].

c Replace the beam connector [3].

d Replace the 2 (M2.0x3.0) screws to secure the beam connector to the system board [4].

Removing and installing components