Service Manual
Table Of Contents
- Precision 5760 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 5760
- Base cover
- Battery
- Memory module
- Solid-state drive in SSD1 slot
- Solid-state drive in SSD2 slot
- Fans
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- I/O board
- Display assembly
- System board
- Antenna
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
Place the palm-rest and keyboard assembly on a flat surface.
Next steps
1. Install the antenna.
2. Install the system board.
3. Install the display assembly.
4. Install the I/O board.
5. Install the right fan.
6. Install the left fan.
7. Install the heat sink (for systems shipped with an integrated graphics card) or the heat sink (for systems shipped with a
discrete graphics card).
NOTE: The system board can be removed or installed together with the heat sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat sink.
8. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive in the SSD2 slot.
9. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive in the SSD1 slot.
10. Install the memory module.
11. Install the battery.
12. Install the base cover.
13. Follow the procedure in After working inside your computer.
54 Removing and installing components