Service Manual
Table Of Contents
- Precision 5760 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 5760
- Base cover
- Battery
- Memory module
- Solid-state drive in SSD1 slot
- Solid-state drive in SSD2 slot
- Fans
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- I/O board
- Display assembly
- System board
- Antenna
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Installing the system board
Prerequisites
NOTE: The Service Tag of your computer is stored in the system board. Enter the Service Tag in the BIOS setup program
after you replace the system board.
NOTE: Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup program.
Make the appropriate changes again after you replace the system board.
About this task
The following image indicates the location of the connectors on your system board.
Figure 2. System-board connectors
1.
Power-button cable 2. Left fan cable
3. Left speaker cable 4. Keyboard cable
5. Right speaker cable 6. Antenna cables
7. Right fan cable 8. Display cable and camera cable
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
46
Removing and installing components