Service Manual
Table Of Contents
- Precision 5760 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 5760
- Base cover
- Battery
- Memory module
- Solid-state drive in SSD1 slot
- Solid-state drive in SSD2 slot
- Fans
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- I/O board
- Display assembly
- System board
- Antenna
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Align the notch on the solid-state drive with the tab on the SSD2 slot.
2. Slide the solid-state drive into the SSD2 slot.
3. Using the alignment post, place the solid-state drive thermal bracket over the solid-state drive.
4. Align the screw hole on the solid-state drive thermal bracket with the screw hole on the system board.
5. Replace the screw (M2x4) that secures the solid-state drive thermal bracket and the solid-state drive to the system board.
Next steps
1. Install the battery
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Fans
Removing the right fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image indicates the location of the right fan and provides a visual representation of the removal procedure.
NOTE:
The fan depicted is for systems with a discrete graphics card, the fan for systems with an integrated graphics card
may appear different but installs in the same manner.
28 Removing and installing components