Owners Manual
Table Of Contents
- Precision 5720 All-in-One Owner’s Manual
- Working on your computer
- Removing and installing components
- USB dongle-bay cover
- Back cover
- Memory module
- Hard drive
- System board shield
- M.2 PCIe SSD
- Memory fan
- Heat sink
- Processor
- Coin cell battery
- WLAN card
- Stand
- System fan
- Power supply unit
- Inner frame
- Built-in self test button
- Microphone
- I/O panel
- USB-dongle port
- Diagnostic light and button board
- Drive cage
- Converter board
- Speaker
- Power button board
- Media card reader
- Camera
- System board
- Display assembly
- Middle frame
- Speaker bezel
- Display panel
- Technology and components
- System setup
- Software
- Troubleshooting
- Technical specifications
- System specifications
- Memory specifications
- Video specifications
- Audio specifications
- Communication specifications
- Connectors
- Display specifications
- Storage specifications
- Port and connector specifications
- Power specifications
- Camera specifications
- Stand specifications
- Physical specifications
- Environmental specifications
- Contacting Dell
v media-card reader
w camera.
3 Press the tabs on the cable to release it from the connector [1].
4 Disconnect the cable from its slot on the middle frame [2].
5 Open the latch and disconnect the display cable from its slot on the middle frame. [3]
6 Lift the display cable o the middle frame [4].
7 Press the tabs on the backlight cable [5].
8 Disconnect the backlight cable from its slot on the middle frame [6].
9 Remove the seven screws (M3X4) that secure the middle frame to the display panel [1].
10 Remove the six screws (M2X3) that secure the middle frame to the speaker bezel [2].
11 Lift the middle frame o the display [3].
64
Removing and installing components