Owners Manual
Table Of Contents
- Precision 5720 All-in-One Owner’s Manual
- Working on your computer
- Removing and installing components
- USB dongle-bay cover
- Back cover
- Memory module
- Hard drive
- System board shield
- M.2 PCIe SSD
- Memory fan
- Heat sink
- Processor
- Coin cell battery
- WLAN card
- Stand
- System fan
- Power supply unit
- Inner frame
- Built-in self test button
- Microphone
- I/O panel
- USB-dongle port
- Diagnostic light and button board
- Drive cage
- Converter board
- Speaker
- Power button board
- Media card reader
- Camera
- System board
- Display assembly
- Middle frame
- Speaker bezel
- Display panel
- Technology and components
- System setup
- Software
- Troubleshooting
- Technical specifications
- System specifications
- Memory specifications
- Video specifications
- Audio specifications
- Communication specifications
- Connectors
- Display specifications
- Storage specifications
- Port and connector specifications
- Power specifications
- Camera specifications
- Stand specifications
- Physical specifications
- Environmental specifications
- Contacting Dell
Installing camera
1 Connect the camera cable to the camera assembly.
2 Turn the camera assembly and route the camera cable through the routing guide on the middle frame.
3 Align the screw holes on the camera assembly with the screw holes on the middle frame.
4 Replace the two screws (M2X3) that secure camera assembly to the middle frame.
5 Install the:
a speakers.
b inner frame
c stand
d back cover
e USB dongle-bay cover
6 Follow the procedure in After working inside your computer
Removing and installing components
55