Owners Manual
Table Of Contents
- Precision 5720 All-in-One Owner’s Manual
- Working on your computer
- Removing and installing components
- USB dongle-bay cover
- Back cover
- Memory module
- Hard drive
- System board shield
- M.2 PCIe SSD
- Memory fan
- Heat sink
- Processor
- Coin cell battery
- WLAN card
- Stand
- System fan
- Power supply unit
- Inner frame
- Built-in self test button
- Microphone
- I/O panel
- USB-dongle port
- Diagnostic light and button board
- Drive cage
- Converter board
- Speaker
- Power button board
- Media card reader
- Camera
- System board
- Display assembly
- Middle frame
- Speaker bezel
- Display panel
- Technology and components
- System setup
- Software
- Troubleshooting
- Technical specifications
- System specifications
- Memory specifications
- Video specifications
- Audio specifications
- Communication specifications
- Connectors
- Display specifications
- Storage specifications
- Port and connector specifications
- Power specifications
- Camera specifications
- Stand specifications
- Physical specifications
- Environmental specifications
- Contacting Dell
Installing media card reader
1 Connect the audio cable to the media card.
2 Connect the media-card reader cable to the media-card.
3 Align the media-card reader to the slot on the middle frame.
4 Align the screw hole on the media-card reader shield to the screw hole on the middle frame.
5 Replace the two screws (M2X3) that secure the media-card reader shield to the middle frame.
6 Install the:
a speakers.
b inner frame
c stand
d back cover
e USB dongle-bay cover
7 Follow the procedure in After working inside your computer
Camera
Removing camera
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a USB dongle-bay cover
b back cover
c stand
d inner frame
e speakers
3 Remove the two screws (M2X3) that secure the camera assembly to the middle frame [1].
4 Remove the camera cable from the routing guide on the middle frame [2].
5 Lift the metal foil and turn the camera assembly over [3].
6 Unrote the cable from the clip and disconnect the camera cable from the camera assembly [4]
54
Removing and installing components