Owners Manual
Table Of Contents
- Precision 5720 All-in-One Owner’s Manual
- Working on your computer
- Removing and installing components
- USB dongle-bay cover
- Back cover
- Memory module
- Hard drive
- System board shield
- M.2 PCIe SSD
- Memory fan
- Heat sink
- Processor
- Coin cell battery
- WLAN card
- Stand
- System fan
- Power supply unit
- Inner frame
- Built-in self test button
- Microphone
- I/O panel
- USB-dongle port
- Diagnostic light and button board
- Drive cage
- Converter board
- Speaker
- Power button board
- Media card reader
- Camera
- System board
- Display assembly
- Middle frame
- Speaker bezel
- Display panel
- Technology and components
- System setup
- Software
- Troubleshooting
- Technical specifications
- System specifications
- Memory specifications
- Video specifications
- Audio specifications
- Communication specifications
- Connectors
- Display specifications
- Storage specifications
- Port and connector specifications
- Power specifications
- Camera specifications
- Stand specifications
- Physical specifications
- Environmental specifications
- Contacting Dell
a USB dongle-bay cover
b back cover
c stand
3 Remove the power-supply unit cable from the routing guides on the system fan [1].
4 Disconnect the power-supply unit cable from its connector on the system board [2].
5 Press the securing clip to release the power-supply indicator cable from its connector [3].
6 Press the securing clip to release the power-supply fan cable from its connector [4].
7 Open the securing clips and release the cables [5].
8 Remove the ve screws (M3X4) that secure the power-supply unit to the middle cover [6].
9 Lift the power-supply unit with the cable o the middle cover [7].
Removing and installing components
31