Owners Manual

Installing processor
1 Ensure that the release lever on the processor socket is fully extended in the open position.
CAUTION
: The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the
processor socket. When the processor is properly seated, all four corners are aligned at the same height. If one or more
corners of the processor are higher than the others, the processor is not seated properly.
2 Align the notches on the processor with the tabs on the processor socket and place the processor in the processor socket.
CAUTION
: Ensure that the processor-cover notch is positioned underneath the alignment post.
3 When the processor is fully seated in the socket, close the processor cover.
4 Pivot the release-lever down and place it under the tab on the processor cover.
5 Install the:
a processor heat-sink.
b system-board shield
c back cover
d USB dongle-bay cover
6 Follow the procedure in After working inside your computer
24
Removing and installing components