Owners Manual

4. Connect the coin-cell battery cable to the system board [1].

5. Connect the fingerprint-reader cable to the system board and close the latch [2].

6. Connect the keyboard-back light cable to the system board and close the latch [3].

7. Connect the display cable to the system board [4].

8. Place the display-cable bracket on the system board and replace the two screws (M1.6x1.8) that secure the bracket to the system

board [5].

9. Affix the tape that secures the display-cable bracket to the system board [6].

10. Connect the camera cable to the system board and close the latch [7].

Removing and installing components