Owners Manual

c) Remove the two I/O-board interposers from the system board [3].

NOTE: Remove the I/O-board interposers immediately after removing the I/O-board cable to prevent the

interposers from falling out of your computer. The pins on the interposer boards are very fragile. Avoid contact

with the pins or bottom of the boards, instead handle the boards by lifting and holding from the edges or side.

After removing the interposer boards from the system, place them on an ESD mat in a location where contact and

movement can be avoided. DO NOT push or apply pressure to the pins on the interposer boards and DO NOT use

any motion that may scratch the pins, such as rotating/turning the boards while they are in contact with any

surface.

Installing the IO board interposer

1. Using the alignment posts, place the two I/O-board interposers on the system board.

Removing and installing components