Owners Manual
Table Of Contents
- Dell Precision 5530 2-in-1 Setup and specifications guide
- Contents
- Set up your computer
- Create a USB recovery drive for Windows
- Chassis
- Keyboard shortcuts
- System specifications
- System setup
- Software
- Replacement media options
- Operating system
- Downloading the audio driver
- Downloading the graphics driver
- Downloading the USB 3.0 driver
- Downloading the Wi-Fi driver
- Downloading the media-card reader driver
- Downloading the fingerprint reader driver
- Downloading the chipset driver
- Downloading the network driver
- Device drivers
- Getting help
Table 26. System Configuration (continued)
Option Description
● 15 min
● Never
Touchscreen It controls whether the screen is enabled or disabled. This option is enabled by default.
Miscellaneous Devices
Allows you to enable or disable the following devices:
● Enable Camera-enabled by default
● Enable Secure Digital (SD) Card-enabled by default
● Secure Digital (SD) Card Boot-disabled by default
● Secure Digital (SD) Card Read-Only-Mode-disabled by default
Video
Option
Description
LCD Brightness Allows you to set the display brightness depending up on the power source—On Battery and On AC. The
LCD brightness is independent for battery and AC adapter. It can be set using the slider.
NOTE: The video setting is visible only when a video card is installed into the system.
Security
Table 27. Security
Option Description
Admin Password Allows you to set, change, and delete the admin password.
System Password Allows you to set, change, and delete the system password.
Strong Password This option lets you enable or disable strong passwords for the system.
Password Configuration Allows you to control the minimum and maximum number of characters allowed for a
administrative password and the system password. The range of characters is between 4
and 32.
Password Bypass This option lets you bypass the System (Boot) Password and the internal HDD password
prompts during a system restart.
● Disabled — Always prompt for the system and internal HDD password when they are set.
This option is enabled by default.
● Reboot Bypass — Bypass the password prompts on Restarts (warm boots).
NOTE: The system will always prompt for the system and internal HDD passwords when
powered on from the off state (a cold boot). Also, the system will always prompt for
passwords on any module bay HDDs that may be present.
Password Change This option lets you determine whether changes to the System and Hard Disk passwords are
permitted when an administrator password is set.
Allow Non-Admin Password Changes - This option is enabled by default.
Non-Admin Setup Changes Determines whether changes to the setup option are permitted when an administrator
password is set.
UEFI Capsule Firmware
Updates
This option controls whether this system allows BIOS updates via UEFI capsule update
packages. This option is selected by default. Disabling this option will block BIOS updates
from services such as Microsoft Windows Update and Linux Vendor Firmware Service
(LVFS)
System setup 25