Owners Manual

Como instalar a tampa da base

1. Coloque a tampa da base do computador e encaixe-a no lugar.

2. Aperte os parafusos que prendem a tampa da base ao computador.

NOTA:

Certifique-se de usar uma chave Torx nº 5 para os parafusos da base e uma chave Phillips para os parafusos

do emblema do sistema.

3. Vire o emblema do sistema e encaixe-a no lugar.

4. Siga os procedimentos descritos em Após trabalhar na parte interna do computador.

Removing the Battery

NOTE:

Discharge the battery as much as possible before removing from the system. This can be done by disconnecting

the A/C adapter from the system (while the system is turned on) to allow the system to drain the battery.

1. Follow the procedures in Before Working Inside Your Computer.

2. Remove the base cover.

3. Perform the following steps to remove the battery:

a) Disconnect the battery cable from the system board [1].

b) Remove the screws that secure the battery to the computer [2].

c) Lift the battery off the computer [3].

• Do not apply pressure to the surface of the battery

• Do not bend

• Do not use tools of any kind to pry on or against the battery

• If a battery cannot be removed within the constraints above, please contact Dell technical support

Como remover e instalar componentes