Owners Manual

Instalar a tampa da base

1. Coloque a tampa da base no computador e encaixe-a no lugar.

2. Aperte os parafusos para fixar a tampa da base no computador.

NOTA:

Utilize uma chave de fendas Torx Nº 5 para os parafusos da base e uma chave de fendas Philips para os

parafusos do crachá do sistema.

3. Vire o crachá do sistema ao contrário e fixe-o no lugar.

4. Siga os procedimentos indicados em Após efectuar qualquer procedimento no interior do computador.

Removing the Battery

NOTE:

Discharge the battery as much as possible before removing from the system. This can be done by disconnecting

the A/C adapter from the system (while the system is turned on) to allow the system to drain the battery.

1. Follow the procedures in Before Working Inside Your Computer.

2. Remove the base cover.

3. Perform the following steps to remove the battery:

a) Disconnect the battery cable from the system board [1].

b) Remove the screws that secure the battery to the computer [2].

c) Lift the battery off the computer [3].

• Do not apply pressure to the surface of the battery

• Do not bend

• Do not use tools of any kind to pry on or against the battery

• If a battery cannot be removed within the constraints above, please contact Dell technical support

Retirar e instalar componentes