Users Guide

ISA Configuration Utility Messages C-11
WARNING: Could not
configure Plug and
Play Card Name.
WARNING: Could not
configure PCI
device,
ID=DeviceID.
Failed to configure
Number of Total
Count Plug and Play
ISA devices. Use
your system’s con-
figuration utility
to resolve con-
flicts. Press any
key to continue.
The card(s) mentioned are
not fully configured due
to resource conflicts.
If you do not know the allowable resource
values for your Plug and Play or PCI expansion
card, use the following procedure to locate
and resolve the resource conflict:
 5H PRYH DOO FDUG FRQILJXUDWLRQV IURP
WKH ,&8
See “Removing a Card” in Chapter 4 for
instructions.
 5HERRW \RXU V\VWHP
The ICU should automatically configure
your Plug and Play or PCI expansion card.
 $GG WKH ,6$ H[SDQVLRQ FDUGV EDFN
LQWR WKH ,&8 UHVROYLQJ DQ\ UHVRXUFH
FRQIOLFWV DV WKH\ DULVH
See “Adding a Listed Card” in Chapter 4
for instructions.
If your Plug and Play or PCI expansion card is
not automatically configured when you reboot
the system with all other cards removed, you
should contact the manufacturer of the card
or see the chapter titled “Getting Help” in
your
Diagnostics and Troubleshooting Guide
.
WARNING: Boot Device
conflict detected!
CSN=Card Select Num-
ber Error=Error.
One of the devices is
attempting to use one or
more resources assigned
to the system’s boot
device.
Perform the following procedure:
 6WDUW WKH ,&8
 ,GHQWLI\ WKH FDUG PDUNHG
config
err

This card is attempting to use one or
more resources required by the system’s
boot device.
 )ROORZ WKH SURFHGXUH IRU WKH SUH
FHGLQJ HUURU PHVVDJH LQ WKLV WDEOH
7DEOH & &RQILJXUDWLRQ 0DQDJHU 0HVVDJHV FRQWLQXHG
0HVVDJH 3UREDEOH &DXVH &RUUHFWLYH $FWLRQ
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
23205BK0.BK : 23205AC0.FM Page 11 Wednesday, March 18, 1998 1:51 PM
Downloaded from www.Manualslib.com manuals search engine