Users Guide

ISA Configuration Utility Messages C-7
&RQILJXUD WL RQ0DQ DJHU 0HVV DJH V
The Configuration Manager for the ICU identifies problems following the system boot
routine and generates messages if necessary. These messages alert you to any
unsuccessful attempts to configure Plug and Play or Peripheral Component Inter-
connect (PCI) expansion cards, as well as any problems that interfere with the
operation of the Configuration Manager. If you receive a message from the Configura-
tion Manager, see Table C-2 for suggestions on resolving any problems indicated by
the message.
You have added a card
using settings differ-
ent from factory
default. Reconfigure
the card to the set-
tings in the next
display (see the card’s
manual) before
installing it.
This message can appear in
two situations:

You added an ISA
expansion card,
selected OK, and the
ICU had to use
resource values differ-
ent from the card’s
defaults to avoid
conflicts.

You added an ISA
expansion card,
selected Advanced,
and chose resource
values different from
the card’s defaults.
Make a note of the new card configura-
tion shown in the Card Resource Usage
dialog box displayed after this message.
Change jumper settings on the ISA
expansion card to match the new card
configuration.
7DEOH & &RQILJXUDWLRQ 8WLOLW\ 0HVVDJHV FRQWLQXHG
0HVVDJH 3UREDEOH &DXVH &RUUHFWLYH $FWLRQ
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
23205BK0.BK : 23205AC0.FM Page 7 Wednesday, March 18, 1998 1:51 PM
Downloaded from www.Manualslib.com manuals search engine