Users Guide

Installing Drives 10-19
*HQHUDO3URFHGXUHIRU,QVWDOOLQJ6&6,'HYLFHV
Configure and install one or more SCSI devices in your computer as follows:
 'HWHUPLQH ZKLFK FRQQHFWRU RQ WKH LQWHUQDO 6&6, FDEOH \RX ZLOO DWWDFK WR
HDFK 6&6, GHYLFH
See “SCSI Configuration Guidelines” found earlier in this section.
 8QSDFN HDFK 6&6, GHYLFH DQG SUHSDUH LW IRU LQVWDOO DWLRQ
&$87,216  *URXQG \RXUVHOI E\ WRXFKLQJ DQ XQSDLQWHG PHWDO VXUIDFH
RQ WKH EDFN RI WKH FRPSXWHU
:KHQ \RX XQSDFN WKH GULYH GR QRW VHW LW RQ D KDUG VXUIDFH ZKLFK PD\
GDPDJH WKH GULYH ,QVWHDG VHW W KH GULYH RQ D V XUIDFH VXFK DV D IRDP
SDG WKDW ZLOO VXIILFLHQWO\ FXVKLRQ LW
Configure the device for a SCSI ID number and disable termination, if necessary.
For instructions, see the documentation that came with the SCSI device as well
as “SCSI Configuration Guidelines” found earlier in this section.
 ,QVWDOO WKH 6&6, GHYLFHV DV DSSURSULDWH

To install a SCSI hard-disk drive
, complete steps 3 through 9 of “Installing an
EIDE Hard-Disk Drive in the Internal Hard-Disk Drive Cage” found earlier in
this chapter. Then continue with step 4 of this procedure.

To install a SCSI tape drive, CD-ROM drive
,
or DAT drive
, complete steps 2
through 6 of “Installing a Drive in a 5.25-Inch Drive Bay” found earlier in this
chapter. Then continue with step 4 of this procedure.

To install an external SCSI device
, continue with step 4 of this procedure.

If you are installing a SCSI host adapter card
, configure the card and install it
in an empty expansion slot (see “Installing an Expansion Card” in Chapter 9.)
If you attach any SCSI hard-disk drives to the host adapter card, connect the
hard-disk drive access cable to the SCSI host adapter card and to the AUX
LED connector on the system board (see Figure 9-1).
 $WWDFK WKH 6&6, FDEOH WR HDFK 6&6, GHYLFH
For additional instructions on connecting SCSI devices, see “SCSI Cables” found
earlier in this section.
If you are installing an internal SCSI device
, firmly press the SCSI cable’s header
connector onto the 50- or 68-pin connector on the back of the device.
&$87,21 <RX PXVW PDWFK WKH FRORUHG VWULS RQ WKH FDEOH ZLWK SLQ  RQ
WKH GULYH·V LQWHUIDFH FRQQHFWRU WR DYRLG SRVVLEOH GDPDJH WR \RXU
V\VWHP
The connectors on Narrow SCSI cables are keyed for proper positioning—a raised
area on the outside of the header connector fits into a notch on the device con-
nector. The connectors on Wide SCSI cables are shaped so that they can be
attached one way only.
23205BK0.BK : 23205100.FM Page 19 Wednesday, March 18, 1998 1:51 PM
Downloaded from www.Manualslib.com manuals search engine