Users Guide

Installing System Board Options 9-15
bezel and slide the drive forward slightly to provide more room for you to work.
See the sections in Chapter 10 titled “Removing and Replacing the Front Bezel”
and “Installing a Drive in a 5.25-Inch Drive Bay” for instructions.
 /RFD WH WKH EDWWHU\ DQG UHPRYH LW
The battery is mounted in a socket labeled “BATTERY” at the upper front-right
corner of the system board (as you face the side of the system) (see Figure 9-1).
&$87,21 ,I \RX SU\ WKH EDWWHU\ RXW RI LWV VRFNHW ZLWK D EOXQW REMHFW EH
FDUHIXO QRW WR WRXFK WKH V\VWHP ERDUG ZLWK WKH REMHFW 0DNH FHUWDLQ WKDW
WKH REMHFW LV LQVHUWHG EHWZHHQ WKH EDWWHU\ DQG WKH VRFN HW EHIRUH
DWWHPSWLQJ WR SU\ RXW WKH EDWWHU\ 2WKHUZLVH \RX PD\ GDPDJH WKH V\V
WHP ERDUG E\ SU\LQJ RII WKH VRFNHW RU E\ EUHDNLQJ FLUFXLW WUDFHV RQ WKH
V\VWHP ERDUG
Pry the battery out of its socket with your fingers or with a blunt, nonconductive
object, such as a plastic screwdriver (see Figure 9-9).
)LJXUH  6\VWHP %D WWHU\ DQ G %DWWHU\ 6RFNHW
 ,QVWDOO WKH QHZ EDWWHU\
Orient the battery with the side labeled “+” facing up. Then insert the battery
into the socket, and snap it into place.
 5RWDWH WKH SRZHU VXSSO\ EDFN LQWR SRVLWLRQ PDNLQJ VXUH WKDW WKH VHFXU
LQJ WDE VQDSV LQWR SODFH
 5HSODFH WKH FRPSXWHU FRYHU DQG UHFRQQHFW \RXU FRPSXWHU DQG SHULSK
HUD OV WR WKHLU SRZHU VRXUFHV DQG WXUQ WKHP RQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
BATTERY socket
battery
23205BK0.BK : 23205C90.FM Page 15 Wednesday, March 18, 1998 1:51 PM
Downloaded from www.Manualslib.com manuals search engine