Users Guide
9-12
Dell Precision 410 Mini Tower Systems User’s Guide
)LJXUH 6(& &DUWULGJH+HDW 6LQN $VVHPEO\ 5HPRYDO
,QVHUW WKH QHZ 6(& FDUWULGJHKHDW VLQN DVVHPEO\ LQWR WKH V\VWHP ERDUG
FRQQHFWRU
Press the SEC cartridge firmly into its connector until it is fully seated and the
latches snap into place. You must use up to 25 lb of force to fully seat the SEC
cartridge in its connector. Install or replace the two large thumbscrews that
secure the heat sink to the system board.
,I QHFHVVDU\ FKDQJH WKH SURFHVVRU VSHHG MXPSHU VHWWLQJ VHH
)LJXUH % WR ORFDWH V\VWHP ERDUG MXPSHUV
The processor speed jumper should be set for the installed microprocessor’s
rated internal speed. For example, for a 350-megahertz (MHz) Intel Pentium II
processor, a jumper plug should be installed on the pins labeled “350MHZ.” (See
Appendix B, “Hardware Configuration Features,” for more information on the
jumpers.)
SEC cartridge
release latches (2)
heat sink
SEC cartridge
guide bracket
assembly
thumbscrews (2)
23205BK0.BK : 23205C90.FM Page 12 Wednesday, March 18, 1998 1:51 PM
Downloaded from www.Manualslib.com manuals search engine