Users Guide
Installing System Board Options 9-9
3UHVV )! WR HQWHU WKH 6\VWHP 6HWXS SURJUDP DQG FKHFN WKH YDOXH IRU
6\VWHP 0HPRU\ LQ WKH ORZHUULJKW FRUQHU RI 3 DJH
The system should have already changed the value of System Memory to reflect
the newly installed memory. Verify the new total.
NOTE: If the memory total is incorrect, turn off and disconnect your computer
and peripherals from their power sources. Remove the computer cover, rotate
the power supply, and check the installed DIMMs to make sure that they are
seated properly in their sockets. Then repeat steps 5, 6, and 7.
:KLOH LQ WKH 6\VWHP 6HWXS SURJUDP UHVHW WKH FKDVVLV LQWUXVLRQ GHWHFWRU
E\ FKDQJLQJ &KDVVLV ,QWUXVLRQ WR 1RW 'HWHFWHG
See Chapter 3, “Using the System Setup Program,” for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
:KHQ WKH 6\VWHP 0HPRU\ WRWDO LV FRUUHFW SUHVV WKH (VF! NH\ WR H[LW WKH
6\VWHP 6HWXS SURJUDP
5XQ WKH 'HOO 'LDJQRVWLFV WR YHULI\ WKDW WKH ',00V DUH RSHUDWLQJ
SURSHUO\
See your
Diagnostics and Troubleshooting Guide
for information on running the diag-
nostics and troubleshooting any problems that may occur.
,QVWDOOLQJ D ',00
If a DIMM is already installed in the socket you want to use, you must remove it. To
do so, follow the instructions in the next subsection, “Removing a DIMM.”
Use the following procedure to install a DIMM (see Figure 9-6):
/RFDWH WKH SODVWLF VHFXULQJ FOLSV DW HDFK HQG RI WKH VRFNHW 3UHVV WKH
FOLSV RXWZDUG XQWLO WKH\ VQDS RSHQ
3UHVV WKH ',00 VWUDLJKW LQWR WKH VORW UXQQLQJ GRZQ WKH FHQWHU RI WKH
VRFNHW XQWLO WKH VHFXULQJ WDEV VQDS LQWR SOD FH DURXQG WKH HQGV RI WKH
',00
23205BK0.BK : 23205C90.FM Page 9 Wednesday, March 18, 1998 1:51 PM
Downloaded from www.Manualslib.com manuals search engine