Owners Manual

Installing the system board

1. Hold the system board by its edges, and align it towards the back of the system.

2. Lower the system board into the system chassis until the connectors at the back of the system board align with the slots on the

chassis rear wall. Move the board toward the rear wall until the screw holes on the system board align with the standoffs on the

system chassis [1].

3. Secure the system board to the chassis with the nine #6 32 screws.

Align the cables with the pins on connectors on the system board and connect power distribution board cable and front panel cable [1],

power distribution board power cable [2], front panel HSD cable, SATA power cable, SATA 0, SATA 1 (if disconnected) cable [3].

5. Reconnect the front panel power cable, GPU power cable [4].

6. Reconnect the SATA 2 power cable and the SATA 2, SATA 3 (if disconnected) cable, and the GPU fan cables [5].

NOTE:

Route all cables through the retention clips that are provided on the system chassis and ensure that no cables

are stuck under the system board during installation.

NOTE: Refer to cable routing picture or document and ensure the cables are properly routed.

74 Removing and installing components