Owners Manual

3. Install the:
a) Top cover
4. Follow the procedure in After working inside your computer.
Removing riser 2 blank
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a) Top cover
b) Riser 2 module
3. To remove the riser 2 blank:
a) Pull the release tab [1] to open the riser2 slot and lift out the riser2 blank from the slot [2].
Installing the riser2 blank
1. Insert the riser2 blank into the slot and close the release tab to secure the riser2 blank in place.
NOTE:
A riser2 blank must be installed over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system. The blank also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
Removing and installing components 71