Owners Manual

Installing the 2.5-inch hard drive backplane
1. Align and place the hard drive backplane in the slot provided on the hard drive cage [1].
2. Fasten the captive screws to secure the backplane to the hard drive cage [2].
3. Reroute the SATA power cable and the SATA connector cables through the cable retention clip [1].
4. Connect the SATA power cable, the SATA 0 connector cable, and SATA 1 connector cable [2].
NOTE:
The blue SATA signal cable plugs into the blue connector on the system board. The black SATA signal cable
plugs into the black connector on the system board.
Removing and installing components 39