Owners Manual

3. Install the Top cover.

4. Follow the procedure in After working inside your computer.

Hard drive assembly

Removing the hard drive assembly

NOTE:

The front accessible hard drive assemblies are not hot pluggable. If the hard drive assembly is removed when the

system is powered up data loss and system failure can occur.

NOTE: The hard drive assembly is applicable for both 2.5 and 3.5 inch hard drives. Only one type of hard drive can be

installed in a system. The 2.5 and 3.5 inch hard drives are not interchangeable.

1. Follow the procedure in Before working inside your computer.

2. Remove the:

a) Front bezel

b) Dust filter

3. To remove the hard drive blank if replacing with a new hard drive.

a) Press the release tabs on the sides of the blank and slide the hard drive blank out of the hard drive slot.

Removing and installing components