Users Guide
Dell Diagnostics
Please Connect USB Keyboard/Mouse to USB Ports on the Back of the Computer. (請將 USB 鍵盤/滑鼠連接至電腦背面的 USB 連接埠。) — 關閉電腦,將
USB 鍵盤和/或滑鼠連接至電腦背面的 USB 連接器,然後重新啟動電腦。
Plug and Play Configuration Error (隨插即用組態錯誤) —
1. 關閉電腦,從電源插座上拔下其電源線,保留一個插卡,將其餘插卡卸下。
2. 插上電腦的電源線並重新啟動電腦。
3. 如果該訊息再次出現,則剛才安裝的插卡可能有故障。如果此訊息不再出現,則關閉電腦並重新插入另一個插卡。
4. 重複此程序,直到識別出有故障的插卡。
Read fault (讀取故障) —
Requested sector not found (未找到要求的磁區) —
Reset failed (重設失敗) —
請參閱「磁碟機問題」。
Sector not found (未找到磁區) —
l 執行 Windows 錯誤檢查公用程式,以檢查軟式磁碟或硬碟機上的檔案結構。請參閱 Windows 說明,以獲得有關指示。
l 如果有大量磁區損壞,請備份您的資料 (如有可能),然後重新為軟式磁碟或硬碟機製作格式。
Seek error (搜尋錯誤) — 請參閱「磁碟機問題」。
Shutdown failure (關機失敗) — 請執行 Dell Diagnostics。
Time-of-day clock stopped (日期時鐘停止) —
Time-of-day not set (未設定日期) —
進入系統設定程式,更正日期或時間。如果問題仍然存在,請更換電池。
Timer chip counter 2 failed (計時器晶片 2 號計數器故障) — 請執行 Dell Diagnostics。
Unexpected interrupt in protected mode (保護模式下出現未預期的岔斷) — 請執行 Dell Diagnostics。
WARNING:Dell's Disk Monitoring System has detected that drive [0/1] on the [primary/secondary] IDE controller is operating outside of normal
specifications.It is advisable to immediately back up your data and replace your hard drive by calling your support desk or Dell (警告:Dell 的磁碟監視系統
已偵測到,[主/次] IDE 控制器上的磁碟機 [0/1] 正在超常規作業。建議您立即備份資料,並與支援服務台或 Dell 公司聯絡,更換您的硬碟機) —
如果沒有可用的替換磁碟機,而該磁碟機又非唯一的可啟動磁碟機,則請進入系統設定程式,將相應的磁碟機設定變更為 None (無),然後從電腦中卸下該磁碟機。
Write fault (寫入故障) —
Write fault on selected drive (所選磁碟機上有寫入故障) —
請參閱「磁碟機問題」。
<drive letter>:\ is not accessible.The device is not ready (x:\ 無法存取,裝置未就緒) — 軟式磁碟機無法讀取磁碟。將軟式磁碟插入磁碟機,然後再試一次。










