Owners Manual
Table Of Contents
- Working inside your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Power-supply unit cage
- Front bezel
- Memory modules
- Solid-state drive
- 2.5-inch hard drive
- 3.5-inch hard drive
- WLAN card
- Slim optical-drive
- Graphics card
- System fan
- Coin-cell battery
- Processor fan and heat-sink assembly
- Processor
- Power button
- Intrusion switch
- Front I/O panel
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Installing the Slim-Optical Disk Drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the slim ODD and provide a visual representation of the installation procedure.
Steps
1. Insert the slim ODD assembly into the ODD slot.
2. Slide the slim ODD assembly until it snaps into place.
3. Route the power cable and data cable through the routing guides and connect the cables to the slim ODD.
Next steps
1. Close the PSU cage
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Graphics card
Removing the graphics card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Open the PSU cage.
Disassembly and reassembly
29