Owners Manual
Table Of Contents
- Precision 3640 Tower Service Manual
- Contents
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw list
- Cover
- PSU hinge
- Bezel
- Memory module
- Hard drive
- Optical drive
- Graphics card
- WLAN module and SMA antenna
- IO panel
- Power button module
- Speaker
- Intrusion switch
- Solid state drive
- Coin cell battery
- Power supply unit
- Front fan
- Top fan
- Heatsink assembly
- Voltage regulator heat sink
- Processor
- System board
- Troubleshooting
- Getting help and contacting Dell
- Optional IO card
- Cable cover
- Dust filter
- Chassis rubber feet
Cable cover
The cable cover for Precision Tower 3640 helps protect ports and cables connected to the system.
About this task
Follow these steps to install the cable cover on the system chassis.
NOTE: Images shown below are for representation only and may vary depending on the system's configuration.
Steps
1. Insert the tab on the security-lock metal bracket into the slot on the rear side of the system [1] and rotate to align the holes
on the metal bracket with screw holders on the chassis [2]
2. Fasten the two #6-32x1/4'' screws to secure the security metal bracket to the chassis [3].
3. Pull the cable release latch and lift the latch away from the cable cover.
B
Cable cover 87