Owners Manual
Table Of Contents
- Precision 3640 Tower Service Manual
- Contents
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw list
- Cover
- PSU hinge
- Bezel
- Memory module
- Hard drive
- Optical drive
- Graphics card
- WLAN module and SMA antenna
- IO panel
- Power button module
- Speaker
- Intrusion switch
- Solid state drive
- Coin cell battery
- Power supply unit
- Front fan
- Top fan
- Heatsink assembly
- Voltage regulator heat sink
- Processor
- System board
- Troubleshooting
- Getting help and contacting Dell
- Optional IO card
- Cable cover
- Dust filter
- Chassis rubber feet
Steps
1. Remove the single (M2x2.5) screw that secures the solid state drive to the system board.
2. Slide the solid state drive and remove it from the system board.
Installing the solid state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicate the location of the solid state drive and provides a visual representation of the installation
procedure.
Disassembly and reassembly
51