Owners Manual

Steps
1. Replace the intrusion switch into its slot in the chassis and slide it in to secure it to the chassis.
2. Route the intrusion switch cable through the routing clips on the chassis and connect the cable to the system board.
Next steps
1. Close the psu hinge.
2. Install the cover.
3. Follow the procedure in after working inside your computer.
Solid state drive
Removing the solid state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the cover.
3. Open the psu hinge.
4. Remove the graphics card.
About this task
The following images indicate the location of the solid state drive and provides a visual representation of the removal procedure.
50
Disassembly and reassembly