Owners Manual
Table Of Contents
- Precision 3640 Tower Service Manual
- Contents
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw list
- Cover
- PSU hinge
- Bezel
- Memory module
- Hard drive
- Optical drive
- Graphics card
- WLAN module and SMA antenna
- IO panel
- Power button module
- Speaker
- Intrusion switch
- Solid state drive
- Coin cell battery
- Power supply unit
- Front fan
- Top fan
- Heatsink assembly
- Voltage regulator heat sink
- Processor
- System board
- Troubleshooting
- Getting help and contacting Dell
- Optional IO card
- Cable cover
- Dust filter
- Chassis rubber feet
Steps
1. Insert the graphics card into the PCIe slot on the system board.
NOTE:
Connect the graphics-card power cable to the connector on the graphics card for a single graphics card
configuration.
2. Insert the PCIe card holder into the slot on the chassis and press it firmly to secure the holder to the top of the graphics
card.
Next steps
1. Close the psu hinge.
2. Install the cover.
3. Follow the procedure in after working inside your computer.
WLAN module and SMA antenna
Removing WLAN module and SMA antenna
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the cover.
3. Open the psu hinge.
About this task
The following images indicate the location of the WLAN module and SMA antenna and provides a visual representation of the
removal procedure.
Disassembly and reassembly
39