Owners Manual
Table Of Contents
- Precision 3640 Tower Service Manual
- Contents
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw list
- Cover
- PSU hinge
- Bezel
- Memory module
- Hard drive
- Optical drive
- Graphics card
- WLAN module and SMA antenna
- IO panel
- Power button module
- Speaker
- Intrusion switch
- Solid state drive
- Coin cell battery
- Power supply unit
- Front fan
- Top fan
- Heatsink assembly
- Voltage regulator heat sink
- Processor
- System board
- Troubleshooting
- Getting help and contacting Dell
- Optional IO card
- Cable cover
- Dust filter
- Chassis rubber feet
2. Slide the holder out from the slot in the chassis.
3. Disconnect the data and power SATA cables from the hard drive.
4. Press the blue securing bracket tabs and lift the hard drive assembly out of the hard drive bay.
5. Flex the hard drive bracket, to disengage the pins.
6. Slide the 3.5-inch hard disk drive out of the bracket.
Removing the 2.5-inch hard drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the cover.
About this task
The following images indicate the location of the 2.5-inch hard drive and provides a visual representation of the removal
procedure.
Disassembly and reassembly 31