Owners Manual
Table Of Contents
- Precision 3640 Tower Service Manual
- Contents
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw list
- Cover
- PSU hinge
- Bezel
- Memory module
- Hard drive
- Optical drive
- Graphics card
- WLAN module and SMA antenna
- IO panel
- Power button module
- Speaker
- Intrusion switch
- Solid state drive
- Coin cell battery
- Power supply unit
- Front fan
- Top fan
- Heatsink assembly
- Voltage regulator heat sink
- Processor
- System board
- Troubleshooting
- Getting help and contacting Dell
- Optional IO card
- Cable cover
- Dust filter
- Chassis rubber feet
Steps
1. Unlock the PSU by sliding the release latches to the 'Unlock' position.
2. Rotate the PSU hinge towards the front of the computer.
Closing the PSU hinge
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the PSU hinge and provides a visual representation of the closing procedure.
24
Disassembly and reassembly