Service Manual

Installing display assembly
1. Place the display assembly to align with the screw holders on the laptop.
NOTE: Close the LCD before inserting the screws or turning over the laptop.
CAUTION: Route the display and antenna cable through the LCD hinge mount holes as LCD assembly is inserted into
the base, to prevent possible cable damage.
2.
Tighten the M2x5 screws to secure the display assembly to the laptop.
3. Turn over the laptop.
4. Connect the antenna cables and display cable to the connectors.
5. Place the display cable bracket over the connector and tighten the M2x5 screws to secure the display cable to the laptop.
6. Install the:
a) hinge cap
b) WLAN card
c) battery
d) base cover
7. Follow the procedure in After working inside your computer.


1. 

 
2. 
a) 
b) 
c)  WLAN
d)  WWAN
e) 
3. 
a) [1]

 

,    LCD  

 LCD
b)  [2]
c)  [3, 4,5]

 LCD  LCD      LCD  
 
44  

