Service Manual

3. Connect the heat sink assembly to the connector on the system board.

4. Install the:

a) battery

b) base cover

5. Follow the procedure in After working inside your computer.

Power connector port

Removing the power connector port

1. Follow the procedure in Before working inside your computer.

2. Remove the:

a) base cover

b) battery

3. To remove the power connector port:

a) Disconnect the power connector port cable from the connector on the system board [1].

NOTE: Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in

breakage.

b) Remove the M2x3 screw to release the metal bracket that secures the power connector port [2].

c) Remove the metal bracket that secures the power connector port [3].

d) Lift the power connector port away from the laptop [4].

Installing the power connector port

1. Insert the power connector port into the slot on the laptop.

Disassembly and reassembly