Service Manual

Installing the keyboard

1. Hold the keyboard and route the keyboard cable and the keyboard backlight cables through the palmrest in the system.

2. Align the keyboard with the screw holders on the system.

3. Replace the M2x2.5 screws (6) to secure the keyboard to the system.

4. Turn the system over and connect the keyboard cable and the keyboard backlight cable to the connector in the system.

NOTE: When reinstalling the chassis frame ensure the keyboard cables are NOT under the lattice , but run through

the opening in the frame before connecting them to system board.

Install the:

a) keyboard lattice

b) battery

c) base cover

6. Follow the procedure in After working inside your computer.

Installing the keyboard trim

1. Align the keyboard trim with the tabs on the computer and press the keyboard until the keyboard clicks into place.

2. Follow the procedure in After working inside your system.

Heat sink

Removing the heat sink

1. Follow the procedure in Before working inside your computer.

2. Remove the:

a) base cover

b) battery

3. To remove the heat sink - :

a) Disconnect the heat sink assembly cable and remove the screws (2) that secure on the system board[1, 2]. .

NOTE:

Remove the screws that secure the heat sink .

26 Disassembly and reassembly