Owners Manual
Table Of Contents
- Working inside your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Intrusion switch
- Front bezel
- Hard-drive assembly
- Hard-drive and optical-drive module
- Optical drive
- Solid-state drive
- WLAN card
- SD card reader - optional
- Expansion card
- Memory modules
- Heat sink
- Coin-cell battery
- Processor
- Power switch
- Power-supply unit
- System fan
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Table 6. System setup options—Storage menu (continued)
Storage
By default, the AHCIoption is enabled.
Storage Interface
Port Enablement Enable or disable the onboard drives.
By default, all the options are enabled.
SMART Reporting
Enable SMART Reporting Enable or disable Self-Monitoring, Analysis, and Reporting Technology
(SMART) during computer startup.
By default, the Enable SMART Reporting option is not enabled.
Drive Information
SATA-0
Type Displays the SATA HDD type information of the computer.
Device Displays the SATA HDD device information of the computer.
SATA-1
Type Displays the SATA HDD type information of the computer.
Device Displays the SATA HDD device information of the computer.
SATA-2
Type Displays the SATA HDD type information of the computer.
Device Displays the SATA HDD device information of the computer.
SATA-3
Type Displays the SATA HDD type information of the computer.
Device Displays the SATA HDD device information of the computer.
M.2 PCIe SSD-0
Type Displays the M.2 PCIe SSD-0 type information of the computer.
Device Displays the M.2 PCIe SSD-0 device information of the computer.
M.2 PCIe SSD-1
Type Displays the M.2 PCIe SSD-1 type information of the computer.
Device Displays the M.2 PCIe SSD-1 device information of the computer.
Enable MediaCard
Secure Digital (SD) Card Enable or disable the SD card.
By default, the Secure Digital (SD) Card option is enabled.
Secure Digital (SD) Card Read-Only Mode Enable or disable the SD card read-only mode.
By default, the Secure Digital (SD) Card Read-Only Mode option is not
enabled.
Table 7. System setup options—Display menu
Display
Multi-Display
Enable Multi-Display Enable or disable the Enable Multi-Display buttons on the computer.
By default, the option is enabled.
Primary Display
System setup 59