Owners Manual

Next steps
1. Install the hard-disk drive and optical-disk drive module
2. Install the 2.5 in. hard drive assembly.
3. Install the Front bezel
4. Install theSide cover
5. Follow the procedure in After working inside your computer.
System fan
Removing the system fan
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5 in. hard drive assembly.
5. Remove the hard-disk drive and optical-disk drive module .
About this task
The following images indicate the location of the system fan and provide a visual representation of the removal procedure.
Steps
1. Disconnect the fan cable from the connector on the system board.
2. Slide the fan grommets towards the slot on the back of the fan chassis.
3. Lift the system fan from the system.
Installing the system fan
Prerequisites
About this task
The following image indicates the location of the VR heat sink and provides a visual representation of the installation procedure.
Steps
1. Align and place the system fan in the system chassis.
2. Pass the grommets through the chassis and slide outward along the groove to secure it in place.
3. Connect the system fan cable to the system board.
Next steps
1. Install the hard-disk drive and optical-disk drive module
2. Install the 2.5 in. hard drive assembly.
3. Install the front bezel.
4. Install the side cover.
5. Follow the procedure in after working inside your computer.
48
Disassembly and reassembly